EnErG Pro 10 BEC ESC (10A) (2-4 Cell)

The JP EnErG Pro ESCs high power BEC has been specifically designed for extreme aerobatics and therefore has the capability to support the higher momentary peak demand loads to eliminate the possibility of unwanted shutdowns. It is also capable of supporting continuous simultaneous multiple servo operations typically found in CCPM equipped hardcore 3D electric helicopters.

BEC Output - 5V/1A

Continuous - 10A (Maximum 10 seconds @ Burst - 12A)

EnErG Pro 10 BEC

Lipo Cells - 2-4 (NiMH Cells - 5-12)

Program Card - 4404925

Programmable - Yes (Manually or by Program card not included)

Size - 21x22x4mm

Weight - 8g

The JP EnErG Pro ESCs high power BEC has been specifically designed for extreme aerobatics and therefore has the capability to support the higher momentary peak demand loads to eliminate the possibility of unwanted shutdowns. It is also capable of supporting continuous simultaneous multiple servo operations typically found in CCPM equipped hardcore 3D electric helicopters.

 Extremely low internal resistance

Super smooth and accurate linear throttle

Over-heat protection feature

Auto throttle shut down at loss of signal

Supports high RPM motors

Power arming protection (prevents the motor from running when accidentally switched ON)

Advanced programming software

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below:

Continue